2026 Beaver Valley Supply Co WFMKX2-160-105 

2026 Beaver Valley Supply Co WFMKX2-160-105

Shipped Complete With

• 1000 RPM Reducer Reverser
• Shielded 20 Spline CV-PTO Driveline With Overload Shear Bolts (21 spline CV-PTO tractor 1/2 shaft Available. This must be specified on the order form. If not specified, we will ship the auger with a 20 spline tractor output shaft)
• Dual Hydraulic Lift Cylinders With Shut-Off Valve
• Low Profile Hopper
• Hydraulic Hopper Lift System
• Remote Electric Power Swing
• Auger Steer
• Transport & Work Light Bundle
• 22.5″ Tires Mounted On Rims

Features May Include:

Open Discharge Spout

• Reduced horsepower requirements
  • 13” auger = 20% less horsepower required
• Allows for more efficient flow out of the tube
• New tapered bearing for increased life span
• Equipped with plastic hood for sleeker appearance
• Included on 10”, 13”, and 16” augers

Steerable Axles

• Improves auger maneuverability around tight corners in transport
• Improves auger maneuverability when lining auger up to the bin hole
• Optional on 13-84/94/114
• Standard on 16” augers

Redesigned Boot

• Separate boot flight with removable shafts (10”, 13”, and 16”)
• AR boot flight standard (13” and 16”)
• Hanger bearing to support boot flight (13” and 16”)
• Tapered lower bearing for increased life span (13”)
• Clean-out doors on both sides of the boot (13”)
• Updated PTO and hose holders (13”)

Transition Neck Flight Support

• Replaced bushing with self-aligning bearing
  • Longer lasting life-span
• Splined connection to hopper u-joint provides better alignment and adjustability
• Included on 13” and 16” augers

30’ Tubes and Flights

• Less tube flange and flight connections lead to less auger noise
• Less tube and flight hardware reduces time needed to assemble
• Common flight and tube lengths leading to less variation to stock
• Included on 10”, 13”, and 16” augers

16” Truss Updates

• Simplified truss connections
  • Fewer components/hardware reducing time to assemble
  • Similar to 13” design
• Simplified truss towers and reduced number of side cable trusses
  • Fewer components/hardware reducing time to assemble
• Adjustable cross brace members

Right Angle Drive

• Improved gearbox stability
• Accepts adjustable tow bar
• New right angle drive with speed reducer
  • Allows auger to be positioned at 90 degree angle from the truck
  • Reduces speed of 1000 RPM tractor to 540 RPM required to run an auger

Auger Lean Prevention

• Vertical stabilizer brace between lower frame arms to lock and prevent tube from rotating in transport position
• Stays engaged through lift assist range of motion as auger is raised and then disengages
• Nylatron GSM material provides a low friction surface to prevent binding
• Included on MKX² 13” a-frame augers equipped with X-Tend or X-Over swings

Cylinder Updates

• Commonize cylinders to use with various auger sizes
  • Fewer cylinders required to stock
• Change from internal check valve to external check valve
  • Easier to access/service/replace in the field

X-Over

• New mechanical drive
  • No hydraulic motor
  • Factory set auger flight and belt speeds
• Redesigned belt interface and added seals to limit leakage
• Redesigned, reinforced drive-over deck and ramps to better handle multiple drive-overs